#Prot on amplifier series#
#Prot on amplifier free#

I've already gone through all the RCA cables, power and ground cables, remote power wire, and speaker wiring.Īny audiophiles have some ideas on what I can do? Thanks in advance. Sub: 1-18' Zv3 with NS coils and cone Sub Amp: Mmats 2100.2 Front Stage: Hybrid Audio L6 mids, SEAS Neo Tweets, SAX 100.4, RF 3sixty. Essentially, the amplifier protect mode is a shutdown state that modern amplifiers go into under a number of different circumstances. Over the years, these amps have benefited from some of Peaveys most popular audio innovations, including our exclusive DDT compression.

#Prot on amplifier series#

It still hits hard but no where as near as hard as it used to, and I'm lost on what adjustment to make or check. CS® 4000 Power Amplifier Building on the reputation of the world-famous Peavey CS 800, which conquered the power amp market in the 1970s, the CS Series is the global standard bearer for workhorse reliability. Olson AM-253 Integrated 32 Watt 6BM8 Tube Amplifier 1965 Dark Grey Japan. When it shuts off I have to turn the key all the way off for a few seconds and then turn it back on.pretty fun doing on the freeway. Proton Model: AM-300 Categories: Amplifiers Year: 1987 Show More. Sometimes I'll have to turn the deck down to -3 or -6 for bass to keep the amp from shutting off. The bass is set at 0, treble all the way up, fade or balance set at neutral. The amp will cut off on a hard-hitting song at 28-30 where I usually listen at, less bass songs can be turned up to sometimes 34. My deck is a Panasonic, and the volume goes from 0-40. The switch is set to LPF where it's always been, sounds like sh*t and becomes hollow sounding if I change it, like it's letting treble and vocals through. If your unit goes into protection mode, it is a good and bad thing- good that further damage is being prevented, but bad in that it may delay the gig. I do not know what LPF or HPF are and it sounds extremely weird if I mess with them.

#Prot on amplifier free#

From memory of where it was originally set, bass boost was 1/2 way up and level was on max. To show the preamp and amp, but also to test my cameras ability to pick up and relay distortion free sound. Overheating Poor installation Unfastened wires Power overload Failed output transistors Interior amp failures Problems in the charging system. LPF: 30-250, x-over switch: LPF-HPF-FULL, HPF: 50-1K, bass boost: 0dB-18dB, level: min-max.

It has the following adjustments from left to right on the amp. This is all listening at the same level that it was able to before, yet the amp cuts out early and refuses to provide as much power.

Also the sound isn't as clear and it cuts off mostly when a song hits very low bass. This review is for the legacy luminance version of this amplifier. Problem is, during that process some knob got turned and now it can't hit as hard without the amp cutting off and going into protection mode. The subs were hitting hard enough to make your hair stand up, but one sub came onhooked inside the box so I disconnected the amp completely and then reconnected the subwoofer. Alright, so I currently have 2 JL Audio 15s and a Nitro 800W amp (200W actually, only 1 20A fuse).